MOLDING INFORMATION | hakkai inc.

The product of our company has a microscopic product plentifully.
Therefore, processing fine a mold and prudent is required.

This is a enlargement of the metallic mold A tip diameter is 7.02. and the edge of the gear is 48.

Product Name:	GEAR	Model:	Sodic AP200 MARK20
Liquid:	Oil	Diameter:	0.03
Material:	PD-613	Wire material:	Tungsten
Thickness:	0.2	Taper:	-
Frequency:	2	Time:	2h
Processing point:	This was processed after setting up only finish requirement. The 2nd amount of offset is the point!

R of a concave portion and a convex part is 0.065, and 0.120 and very fine processing, respectively.

We adopted the wire cut of a diameter 0.03 for realization of this processing.
Although the manufacturer who is competent by mass production in a 0.03mm wire cut thinner than the hair is often seen in the clock industry, Such a thing is rare in our industry.

As a result of beginning to perform such processing from five years before, the mold which can also meet the severe demand of the customer in every direction, such as technology and a lead time cost side, was completed.

Flow analysis (mold flow) supports this mold technology.
Flow analysis is needed especially at the times, such as a connector (2mm pitch of commas) of a small pitch.
In a mold design phase, since the simulation quite near the actual condition can be performed, it is especially used for large figure products, such as an instrument panel of a car.
We are applying this to a small product, and realized stabilization of quality, and shortening of a lead time.

Please the direction of a trouble consults with fineness and thinness right or wrong once.
We offer the product supported by such metallic mold technology and simulation technology.